Germania AS 710 Traducción Del Manual Original página 29

Troubleshooting
Fault
The saw runs, but does not cut
The saw cuts only when it is forced
strongly, resulting in the production
of only a small amount of sawdust and
some larger splinters
The motor of the saw does not start
when the trigger is pressed
The motor of the saw runs, but the
chain does not move
The chain is not supplied with oil
The chain has become detached from
the chain guide bar
Smoke is coming from the saw
The saw leaks – oil leaks out
Possible cause
The chain is assembled upside down
on the chain guide bar
The chain is blunt
Switch lock has not been pressed to
release the trigger
Worn motor brushes
Gear wheel faulty
The oil slot on the chain guide bar is
clogged
The oil tank is empty
The oil is too thick
The chain is too loose
The chain guide bar and chain are
incorrectly assembled
The saw is damaged Do not use the
saw
The oil cap is not closed
Remedy
Read the available information on
assembling the chain guide bar and
saw chain
Read the available information on
sharpening the saw chain
Press the switch lock before pressing
the trigger
Call authorised service centre
Call authorised service centre
Remove the chain guide bar and clean
the oil slot
Fill up with oil
Use the correct oil (read the available
information on filling the oil tank).
Tighten the chain Read the available
information on adjusting the chain
tension
Read the available information on
assembling the chain guide bar and
saw chain
Call an authorised service centre
Tighten the oil cap Note: Empty the oil
tank whenever the saw is not in use
ENGLISH
28