Data Management; Recalling Stored Values; Deleting Stored Values - Soehnle SYSTO MONITOR 100 Instrucciones De Manejo

DATA MANAGEMENT

Recalling stored values

1. Push ( ) to switch the blood pressure
EN
monitor on. The average value of the last three
datasets will be displayed.
2. Push the key (
desired datasets. While scrolling, the number
of the displayed dataset and the total number
of stored measurements will be shown in the
upper right corner.
If you leave a dataset displayed, date and
time of the measurement will also be shown.
They will be put through automatically.
3. If you would like to recall the datasets of anoth-
er user, first push the key (
device off if the blood pressure monitor is still in
the "recall memory" mode.
38
) or ( ) to get to the
) to switch the
Push and hold the key (
"select user", push the key (
between user 1 and user 2. Push the key (
to confirm the user, then recall the measured
datasets of the selected user with (
The most current dataset (1) is shown first.
Each new measurement is stored at dataset
(1). All other datasets are moved back by one
(2 becomes 3, etc.) and the last dataset (60)
is removed from the list.

Deleting stored values

If a measurement is not performed correctly, you
can delete all measurement results for the selected
user as follows.
1. Push and hold key (
) to enter the mode
) again to select
)
).
) for approximately 3