Data Management; Recalling Stored Values; Deleting Stored Values; Data Transmission - Soehnle SYSTO MONITOR CONNECT 400 Instrucciones De Manejo

DATA MANAGEMENT

Recalling stored values

1. Push ( ) to switch the blood
EN
pressure monitor on. The average
value of the last three datasets
will be displayed.
2. Push the key ( ) or ( ) to get to
the desired datasets. While scroll-
ing, the number of the displayed
dataset and the total number
of stored measurements will be
shown in the upper right corner.
If you leave a dataset displayed, date and time
of the measurement will also be shown. They
will be put through automatically.
3. If you would like to recall the
datasets of another user, first
push the key (
device off if the blood pressure
monitor is still in the "recall me-
mory" mode.
Push and hold the key ( ) to
enter the mode "select user",
push the key ( ) again to select
between user 1 and user 2. Push
the key ( ) to confirm the user,
then recall the measured datasets
of the selected user with ( ).
The most current dataset (1) is shown first.
Each new measurement is stored at dataset
(1). All other datasets are moved back by one
(2 becomes 3, etc.) and the last dataset (60) is
removed from the list.

Deleting stored values

If a measurement is not performed
correctly, you can delete all measu-
rement results for the selected user
as follows.
26
) to switch the
1. Push and hold key ( ) for
approximately 3 seconds while
the blood pressure monitor is in
the "recall memory" mode. "dEL
ALL" (delete ALL) will flash and the
selected user will be displayed.
Push ( ) to exit the "delete" mode without
deleting datasets.
2. Push ( ) to confirm deletion, and
"user+dEL done" will be displayed.
The blood pressure monitor then
switches off automatically.

Data transmission

After each measurement, your
personal blood pressure information
is transmitted via Bluetooth to your
mobile device on which the Soehnle
Connect app is installed.
1. After the measurement, the
Bluetooth symbol ( ) flashes on
the top right of the screen. If a
connection with your mobile de-
vice is established, the Bluetooth
symbol ( ) freezes.
2. The new measurement data will
be transmitted after a successful
connection with your mobile
device has been established.
3. After successful transmission,
the Systo Monitor Connect 400
displays "done" on the screen.
In the event of an error during data transmis-
sion, all stored values (for both users) can be
re-send. To do this, push and hold the start/
stop button for 3 seconds until the Bluetooth
symbol flashes on the screen. Then repeat steps
2 and 3.