Data Management; Recalling Stored Values; Deleting Stored Values - Soehnle SYSTO MONITOR CONNECT 300 Instrucciones De Manejo

DATA MANAGEMENT

Recalling stored values

1. Push ( ) to switch the blood
EN
pressure monitor on. The
average value of the last three
datasets will be displayed.
2. Push the key (
to the desired datasets. While
scrolling, the number of the
displayed dataset and the total
number of stored measure-
ments will be shown in the
upper right corner.
If you leave a dataset displayed, date and
time of the measurement will also be
shown. They will be put through automat-
ically.
3. If you would like to recall the
datasets of another user, first
push the key (
the device off if the blood pres-
sure monitor is still in the "recall
memory" mode.
Push and hold the key (
enter the mode "select user",
push the key (
between user 1 and user 2. Push
the key (
user, then recall the measured
datasets of the selected user
with ( ).
30
) or ( ) to get
) to switch
) to
) again to select
) to confirm the
The most current dataset (1) is shown first.
Each new measurement is stored at dataset
(1). All other datasets are moved back by
one (2 becomes 3, etc.) and the last dataset
(60) is removed from the list.

Deleting stored values

If a measurement is not perfor-
med correctly, you can delete
all measurement results for the
selected user as follows.
1. Push and hold key (
approximately 3 seconds while
the blood pressure monitor is
in the "recall memory" mode.
"dEL ALL" (delete ALL) will flash
and the selected user will be
displayed.
Push ( ) to exit the "delete" mode wi-
thout deleting datasets.
2. Push ( ) to confirm deletion,
and "user+dEL done" will be
displayed. The blood pressure
monitor then switches off
automatically.
) for