Descargar Imprimir esta página

cecotec Conga 1890 Manual De Instrucciones página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
Charging base
Fig. 6.
1. Signal transmission area
2. Charging terminal
3. Charge indicator
4. Cable slot
5. Charging terminal
Main brush
Fig. 7.
Brush made of silicone and bristles, designed to clean all types of surfaces.
Mop
Fig. 8.
1. Mop
2. Mop bracket
3. Velcro
4. Tab
Silicone brush
Fig. 9.
Special brush for pet hair.
Cepillo Jalisco (brush)
Fig. 10.
Specific brush for hard floors.
Magnetic Strip
Fig. 11.
Use the magnetic strip provided to set up a Magnetic wall to delimit a certain zone, to which
the robot will not be able to access and clean. For example, place the magnetic strip from one
door's frame to the other in order to forbid the robot from crossing to a room.
Power adapter
Fig. 12.
28
3. BEFORE USE
Take the product out of the box.
Remove all packaging material Save the original box.
Make sure all parts and components are included and in good conditions. If any sign of visible
damage is observed, contact immediately with the official Technical Support Service of Cecotec.
Remove all objects around the robot such as clothing, papers, cables, curtains or other fragile
objects.
If the area to be cleaned has a balcony or stairs, a physical barrier must be placed in order to
prevent product damage and ensure safe operation.
4. INSTALLATION
Robot and charging base installation
Fig. 13.
Connect the charging base to a power supply and store the remaining cable. It is important to
store the remaining cable at the bottom of the charging base to avoid it from being dragged
and disconnected.
Place the charging base against the wall, leaving the safety distance indicated in the below
picture.
Note: Ensure a space of at least 1 m on both the left and right side of the charging base, and a
space of at least 2 m in front of it.
Warning: Do not expose the charging base to direct sun light.
Long press the power button for 3 seconds; when the light indicator turns on, place the robot
on the charging base. Fig. 14.
Steady blue light: ON/operating
Oscillating orange light: Charging
Red light blinks: Error
Note:
Take the robot to the charging base if the battery is low. The robot might not turn on if the
battery is very low.
The robot will automatically turn on when placed on the charging base.
The robot cannot be turned off during charging.
ENGLISH
29

Publicidad

loading

Este manual también es adecuado para:

05408