Teuco X762 Manual Del Usuario página 22

EN
CLEANING THE ELECTROLYTE CELL
The-electrolyte-cell-must-be-kept-in-excellent-condition-in-order-not-to-adversely-affect-its-useful-lifetime.
If- the- system- is- used- according- to- the- instructions- in- this- manual- and- more- specifically,- if- the- balance-
of- the- water- is- maintained- within- the- recommended- parameters,- it- will- not- be- necessary- to- clean- the-
electrodes-manually.
N.B. To prevent damage to the cell, reduce the use of other treatment substances (flocculates,
anti-alga treatments, etc.) to a minimum; these substances are not required if the water
parameters are kept constantly to within the correct values!
CHECKING THE CHLORINE LEVEL IN THE WATER
Analyse-the-amount-of-chlorine-in-the-water-of-the-minipool-using-a-control-kit.
If- the- chlorine- value- for- the- water- in- the- minipool- is- too- low,- increase- the- ORP- value- (see- the- section-
entitled- "SETTING- THE- WATER- DISINFECTING- POWER- (ORP)")- and/or- keep- the- system- operating-
longer-in-"MAN"-mode.
If- the- chlorine- value- for- the- water- in- the- minipool- is- too- high,- reduce- the- ORP- value- (see- the- section-
entitled-"SETTING-THE-WATER-DISINFECTING-POWER-(ORP)")-and/or-keep-the-system-operating-for-
less-time,-choosing-one-of-the-filtering-programs-that-requires-a-lower-system-operating-time.
Check the correct production of chlorine on a regular basis.
If suitable chlorine levels are not found after a period of regular operation, contact your nearest
Authorised Technical Assistance Centre (see list attached).
ADDING SALT TO THE POOL WATER
Add- 500- g- normal- salt- (NaCl)- for- human-
consumption-when-the-display-reads-"LOW-SALT"-
and- leave- the- minipool- operating- for- around- 30
minutes.
Make-sure-that-the-display-no-longer-reads-"LOW-
SALT".
If-this-is-not-the-case,-repeat-the-operation.
For optimum saline level control, use a salinity
detector.
22
pH Electrolysis
7.0
ORP
7.8
LOW SALT
Setpoint Control Mode
WATER-TREATMENT-KIT
ORP mV
690
700
Setpoint