TROUBLESHOOTING
PROBLEMA
GREEN WATER, SLIPPERY
SIDES, GREEN BUILD-UP ON
THE WALLS
THE WATER IS NOT VERY
CLEAR AND THERE IS WHITE
OR GREYISH BUILD-UP ON THE
WALLS AND ACCESSORIES
CORROSION TO ACCESSORIES,
APPEARANCE OF DARK
MARKS
EYE IRRITATION;
DISCOLOURATION TO
CLOTHES AND HAIR
DISCOLOURED WATER
FOAM
WATER-TREATMENT-KIT
DIAGNOSTICA
Presence- of- alga- caused- by- the- low-
level-of-pure-chlorine
pH-in-excess-of-8.0,-faulty-filtering,-high-
degree-of-total-alkalinity.
High- concentration- levels- of- pure-
chlorine-and/or-pH-of-less-than-7.0
High- concentration- levels- of- pure-
chlorine-and/or-pH-of-less-than-7.0
Presence-of-dissolved-metals
High- levels- of- organic- material- in- the-
water
SOLUZIONE
Carry-out-an-intensive-treatment.
Increase- the- pure- chlorine- level- up- to-
2---3-ppm-or-add-a-minimum-amount-of-
flocculate.
Adjust-the-pH-setting-to-7.2---7.6.
Filter-without-interruption-for-8-hours.
Sweep- the- sides- and- bottom- of- the-
pool.
Repeat-the-intensive-treatment-until-the-
problem-is-solved.
Check-the-filter.
Adjust-the-pH-setting-to-7.2-–-7.6.
Add-a-minimum-amount-of-flocculate.
Sweep- the- sides- and- bottom- of- the-
pool.
Filter-for-quite-a-few-hours.
Change-some-or-all-of-the-water.
Adjust-the-pH-setting-to-7.2---7.6.
Adjust- the- production- level- again- for-
the- electrolysis- system- or- change- the-
filter-time.
Change-some-or-all-of-the-water.
Adjust-the-pH-setting-to-7.2---7.6.
Adjust- the- production- level- again- for-
the- electrolysis- system- or- change- the-
filter-time.
Carry- out- an- intensive- treatment- with-
pure-chlorine-powder-(5-g/m3).
Adjust-the-pH-setting-to-7.2---7.6.
Add-a-minimum-amount-of-flocculate.
Filter-without-interruption-for-8-hours.
Sweep- the- sides- and- bottom- of- the-
pool.
Empty- out- the- required- amount- of-
water-and-replace-it-with-fresh-water.
Carry-out-an-intensive-treatment.
Increase- the- pure- chlorine- level- up- to-
2---3-ppm.
Adjust-the-pH-setting-to-7.2-7.6.
Filter-without-interruption-for-8-hours.
EN
25