Publicidad
Idiomas disponibles
Idiomas disponibles
CALIBRATING THE pH DETECTION ELECTRODES
At-regular-intervals-of-no-more-than-one-month,-compare-the-pH-value-of-the-water-in-the-pool-with-that-
detected-by-the-automatic-treatment-system,-using-the-kit-supplied.
If-the-pH-values-differ-by-more-than-0.3-–-0.4,-then-the-pH-detection-electrode-will-need-to-be-readjusted.
Contact your nearest Authorised Technical Assistance Centre (see list attached).
CALIBRATING THE ORP (Chlorine) DETECTION ELECTRODE
At-regular-intervals-of-no-more-than-one-month,-check-the-value-for-the-chlorine-in-the-water.
In-the-event-of-excess-or-insufficient-chlorine,-increase-or-reduce-the-ORP-value-as-required-within-the-
range-permitted-by-the-device.
If-in-this-case,-too,-the-amount-of-chlorine-is-not-regular,-it-may-be-necessary-to-adjust-the-ORP-probe.
Contact your nearest Authorised Technical Assistance Centre (see list attached).
PLACING OUT OF SERVICE
FOR THE WINTER
Disenable- chlorine- production- by- pressing- the-
"Stop"-key.
1.-Disconnect-the-circuit-using-the-two-valves-and-
remove- the- probes,- keeping- them- damp- at- the-
ends-(For-long-periods).
Contact- your- nearest- Authorised- Technical-
Assistance- Centre- (see- list- attached)- to- perform-
this-operation.
2.-Keep-the-circuit-where-the-probes-are-housed-
flooded- (for- brief- periods)- by- turning- off- the- two-
circuit- shut-off- valves;- alternatively,- remove- the-
probes-and-place-them-in-their-original-packaging,-
taking-care-to-keep-them-wet-at-all-times.
Before using the water treatment kit again after
it has been left idle for the winter, proceed as
described for starting the system for the first
time.
WATER-TREATMENT-KIT
pH
Electrolysis
ORP mV
7.0 ... 7.8 pH
Setpoint
Control Mode
Setpoint
AUTO
SET
MAN
CAL
STOP
pH CONTROLLER
ORP CONTROLLER
ON
ALARM
EN
650...800 mV
SET
CAL
23
Publicidad
