Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
If a condition listed below occurs, please check the following items before calling the Technical
Assistance.
Problem
The unit doesn't
operate
The
dehumidifying
function doesn't
work
No air is
discharged
Operation is
noisy
E1 Code
NOTE:
The indication of "LO" and "HI" is not an error code, but an information. See Manual page 59.
65
Possible Cause
Has the power cord been disconnected?
Is the tank full indication lamp blinking?
(The tank is full or in a wrong position.)
Is the temperature of the room above
35℃ or below 5℃?
Is the air filter clogged?
Is the intake duct or discharge duct
obstructed?
Is the air filter clogged?
Is the unit tilted or unsteady?
Is the air filter clogged?
Coil sensor short circuit or open circuit
Solution
Plug the power cord into the
outlet.
Empty the water in the
drainage tank and then
reposition the tank.
The protection device is
activated and the unit cannot
be started.
Clean the air filter as
instructed under "Cleaning
the dehumidifier".
Remove the obstruction from
the discharge duct or intake
duct.
Clean the air filter as
instructed under "Cleaning
the dehumidifier".
Move the unit to a stable,
sturdy location.
Clean the air filter as
instructed under "Cleaning
the dehumidifier".
Check whether the line is
loose or replace the coil
sensor.
Publicidad
