User Menu; Setting Operational Parameters (User Level); Setting Of Operational Mode (Hot/Cold); Setting Of Cooling Temperature - AERMEC MODUCONTROL Manual De Instrucciones

To access the USER menu, press the
key in (Fig.7). Once the key has been
pressed, you must insert the password
to access the various menus; to access
the user menu, the password is 000 (di-
splayed by default). To modify the value
of the passwords, use the arrow keys.
When you have inserted the correct
PASSWORD = 000

Setting operational parameters (user level)

MIN
Index - String
value
0
MIN
Index - String
value
-20 °C
Parameter visible ONLY on units suitable for the production
of hot water
Parameter visible ONLY on units suitable for the production
of DHW

USER menu

password, press the key in (Fig.7). The
monitor will show the index of the USER
parameter and a 3-character string that
identifi es it; the string will be displayed
for one second, after which it is repla-
ced by the value of the parameter itself.
To move on to the next parameter, use
the arrow keys (Fig.8). To modify a pa-
Fig.7

Setting of operational mode (HOT/COLD)

MAX
value
This parameter identifies the functioning mode set for the unit:
• set value = 0 - Cooling mode;
1 • set value = 1 - Heating mode.
In cooling only units, this parameter is displayed but it cannot be modified.
In software versions prior to 3.75, to make the season change the unit must be in standby.

Setting of cooling temperature

MAX
value
26 °C This parameter indicates the value of the work setting active in cooling mode.
rameter, just select it, press the key in
(Fig.7), modify the assigned value using
the arrow keys in (Fig.8), and confi rm
the modifi cation by pressing the key in
(Fig.7) again.
Fig.8
Parameter function
Parameter function
Parameter visible ONLY on units with condensation control
device on board
Parameter ONLY visible on units fitted with twin compressor
Parameter ONLY visible on units fitted with inverter com-
pressor
IMDCFJ. 12.05 6343841_03
53
EN