Ivoclar digital PrograPrint Cure Guía Breve página 7

Improper use
Switching off the device by the user
during operation or opening the door
whilst a program is in progress
2.1.2 Intended user
The device may only be operated by dental technicians and qualified dental staff for the
fabrication of dental objects for dental applications.
The user is responsible for selecting the correct device settings.
2.1.3 Intended environment
The device is only permitted for use in closed rooms within the specified ambient
conditions (see technical data in the Operating Instructions, "Documents of equal
applicability and required files", page 5) and in compliance with the requirements for
safe installation (see requirements regarding the location site, "Documents of equal
applicability and required files", page 5).
Consequences
– Interruption or cancellation of the
curing process/program
– Objects not completely cured
– Insufficient material properties in
terms of mechanics, colour, precision,
biocompatibility
Note:
If a curing job in progress is cancelled, it
cannot be continued.
It is not possible to perform a post-curing
procedure after a program cancellation
as this would lead to an undesirable
change in the material properties.
2.2. Operator's obligations
The operator is responsible for the safe operation of the device.
f Ensure compliance and control:
– Intended use
– Statutory or other safety and accident prevention regulations
f Only operate the device in a technically perfect condition, in a proper, safety-
conscious and risk-conscious manner and while observing the Operating Instructions
("Documents of equal applicability and required files", page 5).
f Keep these instructions and all documents of equal applicability complete, legible and
accessible to personnel at all times.
2.3. Personnel qualifications
f Ensure that the personnel assigned to work with the device have read and understood
these instructions and all documents of equal applicability, in particular safety,
maintenance and repair information, before starting work.
f Ensure that personnel is aware of hazards and safety equipment ("Working areas,
potential hazards and safety measures on the device", page 8).
f Manage the responsibilities, competence and monitoring of staff.
f All work must only be carried out by qualified technical staff.
f Personnel to be trained should only be working with the device under the supervision
of qualified technical staff.
2.4. Staff obligations
f Only operate the device in a technically perfect condition, in a proper, safety-
conscious and risk-conscious manner and while observing the Operating Instructions
("Documents of equal applicability and required files", page 5).
f Refrain from any process that could endanger personnel or third parties.
f In the case of safety-related malfunctions, switch off the device immediately and
allow the fault to be rectified by the person responsible.
f In all cases of doubt regarding the safety of the device, switch off the device and
prevent further use.
7