Publicidad
Idiomas disponibles
Idiomas disponibles
10. Attach the black cable to the negative (-) terminal
on the battery and install the nut, the screw and the
terminal cover.
11. Install the battery cover and the attach the strap.
Tire pressure
Make sure to have the correct tire pressure on all 4 tires.
Technical data on page 41 .
Refer to
Cutting deck
To remove and install the cutting deck
1. Disengage the cutting deck and stop the engine.
2. Put the cutting deck in the lowest position.
3. Remove the 2 screws and the left belt cover.
4. Remove the 2 screws and the right belt cover.
5. Move the drive belt off the left blade pulley to
decrease the tension of the drive belt.
6. Remove the drive belt from the engine pulley.
7. Do the steps that follow to disconnect the front link.
28
a) Remove the clip (A) and the washer (B).
b) Disconnect the front link (C) from the bracket (D)
on cutting deck.
8. Do the steps that follow to disconnect the 2 rear
links. There is one rear link on the left side and one
rear link on the right side of the product.
WARNING:
heavy. Use a crowbar or equivalent
below the cutting deck to hold the weight
of the cutting deck when you disconnect
the 2 rear links.
a) Remove the clip (E), the washer (F) and the pin
(G) on the left and the right side.
G
E
F
b) Move the cutting height lever to the highest
position.
9. For the TC 112 model, do the steps that follow to
disconnect the clutch cable.
B
A
C
D
The cutting deck is
1903 - 002 - 06.02.2023
Publicidad
