Publicidad
Idiomas disponibles
Idiomas disponibles
to the belt routing decal on the cutting
deck.
To adjust the anti-scalp wheels
The anti-scalp wheels keep the cutting deck in the
correct position on the ground and prevent lawn scalping
in most terrain conditions. The anti-scalp wheels are
adjusted correctly when they are slightly off the ground
when the cutting deck is at the necessary cutting height.
1. Park the product on a level surface and stop the
engine.
2. Put the cutting deck in the necessary cutting height.
To set the cutting height (TC 112) on page
Refer to
19 or To set the cutting height (TC 114) on page 19 .
3. Remove the nut (A), the bolt (B), the washer (C), the
anti-scalp wheel (D), and the bushing (E).
D
C
B
4. Install the anti-scalp wheel, the bushing, the bolt, the
washer, and the nut in 1 of the 3 holes.
5. Adjust all anti-scalp wheels in the same procedure.
To do a check of the engine oil level
1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
32
A
E
5. Put the dipstick back in and tighten it.
6. Loosen and pull the dipstick out and read the oil
level.
7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Fill the oil through the hole that the dipstick sits in.
Fill the oil slowly.
Note:
Technical data on page 41 for the
Refer to
types of engine oil that we recommend. Do not mix
different types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.
To replace the engine oil
If the engine is cold, start the engine and let it operate
for 1–2 minutes before you drain the engine oil. This
makes the engine oil warm and faster to drain.
WARNING:
for more than 1–2 minutes before you drain
the engine oil. The engine oil becomes very
hot and can cause burn injuries. Let the
engine become cool before you drain the
engine oil.
WARNING:
your body, clean with soap and water.
Do not operate the engine
If you spill engine oil on
1903 - 002 - 06.02.2023
Publicidad
