Husqvarna TS 112 Manual De Usuario página 14

1. Put the knob (A) onto the throttle control lever.
A
C
2. Install the nut (B) and the screw (C).
To install the seat
Assembly overview on page 13 for the correct
Refer to
fasteners for this task.
1. Hold the seat in position and install the 2 screws (A)
and the 2 nuts (B).
A
2. Do a check of the operator presence control. Refer
Operation conditions on page 10 .
to
WARNING:
product if the operator presence control
is defective.
To adjust the seat
1. Fold the seat forward.
14
B
A
B
Do no operate the
2. Loosen the 2 quick knobs.
3. Move the seat until it is in a position where you can
push the pedals down fully.
4. Tighten the 2 quick knobs fully.
To install the tow bar
Assembly overview on page 13 for the correct
Refer to
fasteners for this task.
• Install the tow bar with the 2 screws.
To connect the battery
WARNING:
Make sure that the ignition switch is in
the off position and that the ignition key is
removed.
The location of the battery is below the seat.
1. Fold the seat forward.
2. Make sure that the red cable is installed to the
positive (+) terminal on the battery.
3. Remove the screw and the nut on the negative (-)
terminal on the battery.
Risk of electric shock.
1825 - 003 - 08.02.2023