ProBreeze PB-13 Manual De Instrucciones página 8

FEATURES
― ―
This dehumidifier uses Peltier Technology (no compressor) making it lightweight and quiet. It is
perfect for small rooms and poorly ventilated areas such as wardrobes, cabinets and storage
rooms that are susceptible to damp odours and fungus. Using this dehumidifier will help eliminate
unwanted moisture from the air.
Switching On
1. Place the appliance on stable and level surface. Connect the power adaptor to the nearest
mains wall socket.
Switch the dehumidifier ON using the ON/OFF switch. The green LED will illuminate and you
2.
should feel a light breeze blowing out of the dry air outlet.
3. To switch OFF, press the ON/OFF switch again.
Emptying the water tank
The dehumidifier can collect up to 500ml (18oz) of water per day and the tank has a maximum
capacity of 1500ml (52oz). When the tank is full, the LED will turn YELLOW and the unit will turn off.
When full, turn OFF the dehumidifier and simply pull the water tank out.
1.
2. Place the water tank a stable surface and remove tank cover using thumb hole and
following instructions below.
3. Then, gently tilt tank over a sink to empty.
4. When done, replace cover on tank and then carefully slot water tank back in.
CLEANING & STORAGE
― ―
WARNING: ALWAYS TURN THE APPLIANCE OFF AND UNPLUG
THE POWER CORD FROM THE ELECTRICAL OUTLET BEFORE
HANDLING OR CLEANING IT.
CAUTION: DO NOT ALLOW WATER OR OTHER LIQUIDS TO
RUN INTO THE INTERIOR OF THE APPLIANCE, AS THIS COULD
CREATE A FIRE AND/OR ELECTRICAL HAZARD.
CAUTION: DO NOT USE ANY ABRASIVE CLEANERS OR
SOLVENTS, AS THIS CAN DAMAGE THE APPLIANCE.
8 of 68 | English