DEFROSTING
― ―
The unit may need defrosting in temperatures less than 16°C. This will happen automatically and
last up to ten minutes. During this time, P1 will show on the display panel and the compressor will
stop collecting water but the fan will continue to run at its prior setting.
Do not switch off while the unit is defrosting.
CONNECTING THE WATER HOSE FOR CONTINUOUS DRAINING
― ―
For long-term use, it is recommended to connect a hose
for continuous drainage. To attach the hose:
1.
Remove the plug from the water hose connector
located on the back of the dehumidifier.
2.
Insert the hose into the water hose connector and
check it is connected properly.
3.
Ensure the hose end has a suitable drainage outlet
(e.g. a drain or bucket).
REMOVING AND EMPTYING THE WATER TANK
― ―
When the water tank is full 10 beeps will sound; the Water
Tank Full indicator light will illuminate, and the dehumidifier
will pause operation to prevent the water tank from
overflowing. To remove and empty the water tank:
1.
Turn off the dehumidifier and unplug it from the wall
socket.
2.
Gently pull the water tank out from the front of the
dehumidifier.
3.
Empty the water tank.
4.
Once empty, slot the tank back in carefully.
CLEANING & STORAGE
― ―
WARNING: ALWAYS TURN THE APPLIANCE OFF AND UNPLUG
THE POWER CORD FROM THE ELECTRICAL OUTLET BEFORE
HANDLING OR CLEANING IT.
CAUTION: DO NOT ALLOW WATER OR OTHER LIQUIDS TO
RUN INTO THE INTERIOR OF THE APPLIANCE, AS THIS COULD
English | 11 of 92