Publicidad
Idiomas disponibles
Idiomas disponibles
Handle gently
Temperature range
No Sterilize requirement
Not category AP / APG equipment
Mode of operation: continuous
5.6 Memory
Each unit stores 120 sets measurements for 2 users, totally 240 sets (User A and B).
Viewing the stored values
With the unit off, press the Memory button. The display first shows "A", then shows an average of all
measurements stored in the unit. Please note: Measurements for each user are averaged and stored
separately. Be certain that you are viewing the measurements for the correct user. Pressing the Memory
button again displays the previous value. To view a particular stored memory, press and hold the
Memory button to scroll to that stored reading.
5.7 Discontinuing a Measurement
If it is necessary to interrupt a blood pressure measurement for any reason (e.g the patient feels unwell),
the Start/Stop button can be pressed at any time. The device then immediately lowers the cuff pressure
automatically.
5.8 Using the AC Adapter
You may also operate this monitor using a CE approved AC adapter (output 5V DC1A with Micro
connector).
a) Ensure that the AC adapter and cable are not damaged.
b) Plug the adapter cable into the AC adapter port on the right side of the blood pressure monitor.
c) Plug the adapter into your electrical outlet. When the AC adapter is connected, no battery current is
consumed.
Note: No power is taken from the batteries while the AC adapter is connected to the monitor. If electrical
power is interrupted,(e.g., by accidental removal of the AC adapter from the outlet) the monitor must be
reset by removing the plug from the socket and reinserting the AC adapter connection.
13
Publicidad
