HOLZMANN MASCHINEN SB 4132SM Manual De Instrucciones página 40

 Install the Chuck. Thoroughly clean the tapered hole in the Chuck and the Spindle shaft of
all dirt, grease, oil, and protective coatings (paint thinner may be necessary). Slide the
Chuck onto the Spindle shaft. Turn the Chuck sleeve clockwise and open the jaws
completely. Tap the nose of the Chuck lightly with a piece of wood to securely set the
Chuck.
 Verify that the Table is square (90 degrees) to the Head Assembly and drill bit.
 Adjust V-Belt tension or change speeds.
- Open the Belt Guard to expose the V-Belt.
- Loosen the Thumb Nut to relieve the V-Belt tension.
- Push the Motor backward, tightening the Belt on the pulleys, and hold in place.
- Turn the Thumb Nut clockwise to tighten the V-Belt in place.
- Refer to the chart inside the Guard lid to select speed and belt locations.
Overtightening the belts can cause the motor to bind and not start.
It can also damage motor bearings!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
WARNING
ASSEMBLY
40
SB 4132SM