Sony BKM-FW31 Manual De Instrucciones página 25

CLOSED CAPTION (closed caption)
Displays closed captions.
When PICTURE MODE is set to User1 or
User2, you can adjust the following items.
Refer to the Operating Instructions of the
FWD series as well.
Contrast +/– buttons
Adjusts the picture contrast.
Brightness +/– buttons
Adjusts the picture brightness.
Chroma +/– buttons
Adjusts color intensity.
Phase +/– buttons
Adjusts color tones.
Setup window
A dialog box prompting you to enter a
Network Password appears. "Name: root"
is preset as the factory setting without a
password.
The settings entered or changed in each
window become valid after you click Apply
located near the bottom of the window.
You cannot enter special characters in this
window.
Owner Information
Owner
Enter information on the owner.
Display Location
Enter the location of the Display unit.
Memo
You can write comments or notes here.
Time
Time
Enter the current time.
Network
Internet Protocol (TCP/IP)
Under normal circumstances, set this item
to "Obtain an IP address automatically
(DHCP)." Enter the required value
(address) if you set it to "Specify an IP
address."
Password
Names and Passwords can be set
individually for the Administrator and each
User. The Name for the Administrator is
permanently set to "root."
Mail Report*
If an error occurs in the Display unit, the
system immediately reports the error by
sending an E-mail (Error Report).
* Except for the FWD-50PX1.
Address (Destination)
Enter an e-mail address in each text box.
The error report can be sent to four
destinations at the same time. The
maximum number of characters of each e-
mail address is 64.
Mail Account
Mail Address:
Enter the e-mail address assigned to this
device.
The maximum number of characters that
can be used in the address is 64.
Outgoing Mail Server (SMTP) (SMTP
server):
Enter the address of the SMTP server.
The maximum number of characters that
can be used in the address is 64.
Requires the use of POP
Authentication before Send e-mail
(POP before SMTP):
Check the "POP before SMTP" check box
when POP authentication is needed before
connecting to the SMTP server.
Ingoing Mail Server (POP3):
Enter the address of the POP3 server to be
used for POP Authentication (POP before
SMTP).
Operations from a Computer
11
GB