Publicidad
Idiomas disponibles
Idiomas disponibles
SPEAKER LED WIRING
To provide power for the LEDs, plug the 24-gauge black (+), blue,
green, and red LED wires from the speaker into the included
female connector, then run the wires from the female connector
to your compatible 12-volt power source or light controller (sold
separately). If using a separate controller, be sure to connect each
wire to the proper output.
Blue
Green
Red
To power source
Black
If hardwiring the LEDs directly to your power source, you can
choose the color of the LEDs by connecting the black wire to the
positive (+) terminal, and the appropriate R, G, and/or B single
wire or combination of wires to the negative (-) terminal.
There are 7 possible colors, depending on the wiring configuration
you choose:
Wire connected
Wire connected
to positive (+12V)
to negative (-)
terminal
terminal
Red
Green
Blue
Black
Red + Green
Red + Blue
Blue + Green
Red + Blue + Green White
APPLYING FOAM SEAL
To help seal your installation against water, and to provide an
airtight acoustic seal, apply the self-adhesive foam seal to the
speaker frame.
MOUNTING THE SPEAKER
1. Use the included screws and drill bit to mount the speaker
to the location. Use the included speed clips if necessary to
provide a secure mount.
NOTE: It might be necessary to drill new speaker-mounting holes
at the mounting location. Use caution when cutting and using
screws with fiberglass to prevent scratches and cracks.
CA_JBL Club Marine Speakers_OM_Global_SOP_V9.indd 3
CA_JBL Club Marine Speakers_OM_Global_SOP_V9.indd 3
To speaker
2. Make sure that the sticker above the tweeter with the arrow
Color produced
ATTACHING THE GRILLE
Red
To attach either the white or grey grille, place it over the speaker
Green
at a slight angle and press down. Then twist it clockwise just a
few degrees to lock into place. Make sure the JBL logo is at the
Blue
bottom.
Yellow
Purple
Aquamarine
MOUNTING THE CLUB 10" OR 12" IN
AN ENCLOSURE
The Club 10" and 12" subwoofers can be mounted in a free-air
application, or in a sealed or ported subwoofer enclosure.
and "TOP" printed on it is aligned with the arrow facing
upward. This will ensure the speaker terminals are facing
downwards to allow water to drain away from them, and that
the grille orientation will be correct. Remove the sticker after
speaker installation.
EN
6/17/2022 4:21:27 PM
6/17/2022 4:21:27 PM
Publicidad
