Publicidad
Enlaces rápidos
Models/Modelos/Modèles
R1817, T1817, T1837, R1827,
T18017, T18037, R1827-XO,
T18017-XO & T18037-XO
Series/Serie/Seria
Write purchased model number here.
Escriba aquí el número del modelo comprado.
Inscrivez le numéro de modèle ici.
You may need/Usted puede necesitar/Articles dont vous pouvez avoir besoin:
INSTALLATION INSTRUCTIONS
Before you start . . . be sure to determine what type of installation
you will be performing, whether or not you will install your jet module
in a thin or thick wall. For thin wall mountings the front surface of the
plasterguard should be flush with your finished wall. For thick wall
mountings there should be no more than 1 1/2 " between the
front surface of the plasterguard and your finished wall.
INSTRUCCIONES PARA LA INSTALACIÓN
Antes de comenzar . . . asegúrese de determinar que tipo de
instalación va a hacer, si instalará o no su módulo a chorro en una
pared delgada o gruesa. Para instalaciones en paredes delgadas la
superficie del frente del protector de yeso debe quedar al ras con su
pared acabada. Para instalaciones en paredes gruesas no bebe haber
más de 1 1/2" entre la superficie del frente del protector de yeso y
su pared acabada.
INSTRUCTIONS D'INSTALLATION
Avant de débuter . . . vérifiez si la paroi où vous voulez installer le
module de giclage est mince ou épaisse. Dans une paroi mince, la
surface avant de la plaque protège-plâtre doit être à égalité de la
surface finie. Dans une paroi épaisse, l'écart entre la surface avant de
la plaque protège-plâtre et la surface finie ne doit pas excéder 1 1/2 po.
www.deltafaucet.com
JETTED SHOWER™ & JETTED SHOWER XO
77493
JET MODULES
REGADERA JETTED SHOWER ™ Y MÓDULOS
JETTED SHOWER XO
MODULES DE GICLAGE JETTED SHOWER
JETTED SHOWER XO
T E FLO N
1
®
®
01/20/2023 Rev. D
®
ET
MC
Publicidad
Manuales relacionados para Delta JETTED SHOWER R1817
Resumen de contenidos para Delta JETTED SHOWER R1817
- Página 1 JETTED SHOWER™ & JETTED SHOWER XO 77493 ® JET MODULES REGADERA JETTED SHOWER ™ Y MÓDULOS JETTED SHOWER XO ® MODULES DE GICLAGE JETTED SHOWER JETTED SHOWER XO ® Models/Modelos/Modèles R1817, T1817, T1837, R1827, T18017, T18037, R1827-XO, T18017-XO & T18037-XO Series/Serie/Seria Write purchased model number here.
- Página 2 Finished Wall Pared Acabada Surface finie du mur Install the jet module at the desired location. The distance (1) from the stringer to the front of the jet spray plasterguard is 2.6" Turn off water supplies. Unscrew test (4) to tighten the sleeve assemblies. (66 mm).
- Página 3 Finished Wall Pared Acabada Surface finie du mur Open Handle Position Ports 1 & 2 2 & 3 1 & 3 Install the jet module at the desired location. The distance (1) Turn off water supplies. Remove assemblies. CAUTION: DO NOT from the stringer to the front of the jet spray bonnet is 2 1/2"...
- Página 4 Finished Wall Pared Acabada Surface finie du mur The R1817 should be used with a Jetted Shower XO model or a ® standard diverter. When using a Jetted Shower XO , outlet (1) is the ® recommended showerhead outlet; and, outlet (2) is the When the jet module is ready for the trim, break off the recommended outlet for the jet module.
- Página 5 77493 Rev. D...
- Página 6 What You Must Do To Obtain Warranty Service or Replacement Parts: A warranty claim may be made and replacement parts may be obtained by calling 1 800 345 DELTA (3358) or by contacting us by mail or online as follows (please include your model number and date of original purchase): ©...