Publicidad
Technical Data
Power Requirements
General Power Tool Safety Warnings
Safety Warnings for Heat Guns
Parts
Preparation
Start Up
Maintenance
Notes
Authorized Service Centers
Warranty Policy
Use and care recommendations
THERMAL PROTECTION
Turns the tool off in case of overheating, let it cool down for
at least 15 minutes.
KEEP THE NOZZLE NO LESS THAN 1 INCH AWAY FROM
THE WORKPIECE, OTHERWISE IT COULD DAMAGE THE TOOL
FULLFILL THE DUTY CYCLES.
Let the device cool down 15 minutes per 30 minutes of operating it,
maximum 3 hour
Perform periodic MAINTENANCE to your tool (page 8).
2
ENGLISH
3
3
4
5
6
7
7
8
9
11
12
PISCA-A
Contents
CAUTION
To gain the best performance of
the tool, prolong the duty life,
make the Warranty valid if
necessary, and to avoid hazards
of fatal injuries please read and
understand this Manual before
using the tool.
Keep this manual for future references.
The illustrations in this manual are for reference
only. They might be different from the real tool.
+
Publicidad
