Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE
○
When used together with the battery, the
AC adapter is the main power source and no
battery power is consumed.
○
The tripod light has no charging function. Using
the AC adapter and battery simultaneously will
not charge the battery.
○
Ensure that the rubber cover of the AC adapter
terminal is securely closed when the AC
adapter is not attached.
If any water or dust enters the body of the tool
or the AC adapter terminal, a failure may occur.
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure
the following points.
○
The power source voltage is stated on the
nameplate.
○
The cord is not damaged.
WARNING
Do not charge at voltage higher than
indicated on the nameplate.
If charged at voltage higher than indicated
on the nameplate, the charger will burn
out.
1.
Connect the charger's power cord to a
receptacle. When the power cord is connected,
the charge indicator lamp will blink in red. (At
1-second intervals)
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
2.
Insert the battery to the battery charger.
Firmly Insert the battery into the battery charger
as shown in Fig. 8.
Pilot lamp
3.
Charging
When inserting a battery in the charger, the
pilot lamp will light up continuously in red.
When the battery becomes fully recharged,
the pilot lamp will blink in red. (At 1-second
intervals.) (See Table 2)
(1)
Lamp indication
The indications of the pilot lamp will be as
shown in Table 2, according to the condition of
the battery charger or the battery.
English
Battery
Fig. 8
13
Publicidad
