Publicidad
Idiomas disponibles
Idiomas disponibles
How to make the batteries perform longer
(1)
Recharge the batteries before they become
completely exhausted.
When you feel that the power of the tool
becomes weaker, stop using the tool and
recharge its battery. If you continue to use
the tool and exhaust the electric current,
the battery may be damaged and its life will
become shorter.
(2)
Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately
after use. If such a battery is recharged
immediately after use, its internal chemical
substance will deteriorate, and the battery
life will be shortened. Leave the battery and
recharge it after it has cooled for a while.
CAUTION
●
When the battery charger has been
continuously used, the battery charger will
be heated, thus constituting the cause of
the failures. Once the charging has been
completed, give 15 minutes rest until the
next charging.
●
If the battery is charged while it is heated
because it has been left for a long time
in a location subject to direct sunlight or
because the battery has just been used,
the pilot lamp of the charger lights for
1 second, does not light for 0.5 seconds
(off for 0.5 seconds).
The battery will not be recharged. In such a
case, let the battery cool before charging.
●
When the pilot lamp fl ickers (at 0.2-second
intervals), check for and take out any
foreign objects in the charger's battery
connector. If there are no foreign objects,
it is probable that the battery or charger is
malfunctioning. Take it to your authorized
Service Center.
HOW TO USE
1.
Tripod light preparation
WARNING
●
Do not use in locations where the light may
fall over.
●
Be sure to open the legs before extending
the pole. (Fig. 9)
Leg
●
Use the product with the legs spread
completely and locked in position.
●
Be careful not to pinch your hands
or fi ngers in the sliding parts during
operation.
CAUTION
Open and close the legs on a fl at surface
free of obstacles. If necessary, anchor the
legs to prevent the tripod from falling over.
(1)
Hold the top handle and carrying handle with
both hands, then push down the leg opening
lever to lower the carrying handle and open the
legs until they lock in place. (Fig. 10)
Leg
opening
lever
Carrying
handle
Leg
English
LED unit
Extension
poles
Fig. 9
Top handle
Fig. 10
15
Publicidad
