Publicidad
Idiomas disponibles
Idiomas disponibles
Keep all screws, bolts and covers tightly in
8.
place.
Keep all screws, bolts, and plates tightly
mounted. Check their condition periodically.
Do not clean this product with a water
9.
spray or the like (Solvents).
Follow manufacturers cleaning instructions.
Solvents such as gasoline, thinner benzine,
carbon tetrachloride, and alcohol may damage
and crack plastic parts. Do not wipe them with
such solvents.
Wipe plastic parts with a soft cloth lightly
dampened with soapy water and dry
thoroughly.
10. Do not use the product if the tool or the
battery terminals (battery mount) are
deformed.
Installing the battery could cause a short circuit
that could result in smoke emission or ignition.
11. Keep the tool's terminals (battery mount)
free of dust.
○
Prior to use, make sure that dust have not
collected in the area of the terminals.
○
During use, try to avoid dust on the tool from
falling on the battery.
○
When suspending operation or after use, do
not leave the tool in an area where it may be
exposed to falling dust.
Doing so could cause a short circuit that could
result in smoke emission or ignition.
12. Always use the tool and battery at
temperatures between 23oF (-5oC) and
104oF (40oC).
IMPORTANT SAFETY INSTRUCTIONS
FOR BATTERY CHARGER
WARNING
Death or serious bodily injury could result
from improper or unsafe use of battery
chargers. To avoid these risks, follow
these basic safety instructions:
READ ALL INSTRUCTIONS
1.
This manual contains important safety and
operating instructions for battery charger
Model UC18YFSL.
2.
Before using battery charger, read all
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product
using battery.
3.
To reduce risk of injury, charge metabo HPT
rechargeable battery models of the multi volt
series and the BSL18 series. Other models of
batteries may burst causing personal injury
and damage.
4.
Use of an attachment not recommended or
sold by the battery charger manufacturer may
result in a risk of fi re, electric shock, or injury to
persons.
5.
To reduce risk of damage to electric plug and
cord, pull by plug when disconnecting battery
charger.
6.
Make sure cord is located so that it will not
be stepped on, tripped over, or otherwise
subjected to damage or stress.
7.
An extension cord should not be used unless
absolutely necessary. Use of improper
extension cord could result in a risk of fi re and
electric shock.
If extension cord must be used make sure:
a. That blades of extension cord are the same
number, size, and shape as those of plug
on battery charger:
b. That extension cord is properly wired and
in good electrical condition; and
c. That wire size is large enough for AC
ampere rating of battery charger as
specifi ed in Table 1.
English
5
Publicidad
