SP6438-5 16 Gallon.qxd
Operation (continued)
Vacuuming Dry Materials
1. The filter must always be in correct
position at all times to avoid leaks and
possible damage to vac.
2. When using your vac to pick up very
fine dust, it will be necessary for you to
empty the drum and clean the filter at
more frequent intervals to maintain
peak vac performance.
NOTE: A dry filter is necessary to pick up
dry material. If you use your vac to pick
up material when the filter is wet, the filter
will clog quickly and be very difficult to
clean.
Vacuuming Liquids
1. When picking up small amounts of
liquid the filter may be left in place.
2. When picking up large amounts of
liquid we recommend that the filter be
removed. If the filter is not removed, it
will become saturated and misting may
appear in the exhaust.
WARNING: Do not remove the
!
filter cage and float. The float
prevents liquid from entering the
impeller and damaging the motor.
3. When the liquid in the drum reaches a
predetermined level, the float
mechanism will rise automatically to cut
off air-flow. You will know that the float
has risen because vac airflow ceases
and the motor noise will become higher
in pitch, due to increased motor speed.
When this happens, turn off the vac,
unplug the power cord, and empty the
drum.
4. After using the vac to pick up liquids, the
filter must be dried to avoid possible
mildew and damage to the filter.
IMPORTANT: To reduce the risk of
damage to the vac, do not run motor with
float in raised position.
Emptying the Drum
WARNING: To reduce the risk of
!
injury from accidental starting,
unplug power cord before emptying
the drum.
4/9/08
12:20 PM
Page 10
1. To remove the lid to empty contents of
the dust drum simply lift the two drum
latches at the front and rear of the dust
drum and lift the lid assembly up and
off the dust drum and set to the side.
2. Lay the lid assembly upside down on a
clean area while emptying drum or
changing the filter.
3. Dump the drum contents into the proper
waste disposal container.
4. If the contents are liquid, you may
dispose by using the drain provided in
the drum for easy emptying. Simply
unscrew the drain cap and allow the
liquid to drain completely out of the vac
drum.
!
back injury or falls, do not lift a vac
heavy with liquid or debris. Scoop
or drain enough contents out to
make the vac light enough to lift
comfortably.
Moving the Wet/Dry Vac
Should it become necessary to pick the
vac up to move it, the handles on the
sides of the dust drum are used to lift. To
maneuver the vac, the pull handle above
the inlet should be used.
Blowing Feature
Your wet/dry vac has a "detachable
lower". It has the capability to be used as
a dedicated blower for yard work, patio
cleanup and workshop applications to
blow sawdust and other debris.
!
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
10
WARNING: To reduce the risk of
WARNING: Always wear safety
Drum
Latch