Bosch Parking Lot Sensor Manual De Usuario página 9

Parking Lot Sensor | PLS 9 | 16
The sensor can be screwed into the base after the adhesive has cured. To simplify insertion, the arrow on the bottom
of the sensor points towards the Bosch logo (see Figure 14 Installing/screwing in the sensor). After inserting the
sensor, it will take approx. 2 minutes until the first measurements are carried out. During this time, the sensor should
be completely screwed in to ensure optimum teaching of the sensor. To tighten it, use the T20 screw and a
T20 screwdriver and tightening torque with at least 1.4 Nm up to a maximum of 1.8 Nm. And then close the opening
with the sensor sealing cap.
Figure 14 Installing/screwing in the sensor
© Bosch Connected Devices and Solutions GmbH 2020. All rights reserved, also regarding and disposal, exploitation, reproduction, editing,
distribution, as well as in the event of application for industrial property rights.