Garmin EDGE EXPLORE 2 Guia De Inicio Rapido página 44

DRAFT
Planning and Riding a Course
You can create and ride a custom course.
A course is a sequence of waypoints
or locations that leads you to your final
destination.
1 Select Courses >
2 Select to add a location.
3 Select an option.
There are many ways to add a
location. For more information, see
your owner's manual.
4 Select Add to Course.
TIP: From the map, you can select
another location, and select Add to
Course to continue adding locations.
5 Repeat steps 2 through 4 until you
have selected all locations for the
route.
TIP: You can swipe left and select
to remove a location.
6 Select an option:
• To calculate the route, select View
Map.
• To calculate the route with the
same route back to the start
location, select
44
7 Select Save > Ride.
> Course Creator.
Creating and Riding a Round-Trip
Course
The device can create a round-trip course
based on a specified distance, starting
location, and direction of navigation.
1 Select Courses >
2 Select Distance, and enter the total
3 Select Start Location.
4 Select an option.
5 Select Start Direction, and select a
6 Select Search.
7 Select a course to view it on the map.
> Out and Back.
• To calculate the route with a
different route back to the start
location, select > Loop to Start.
A map of the course appears.
> Round-Trip
Course.
distance for the course.
There are many ways to add a
location. For more information, see
your owner's manual.
direction heading.
TIP: You can select
again.
Guía de inicio rápido
to search