Publicidad
Step
Step 13
Carefully stand your unit upright and position the unit in its fi nal location. We recommend using the SAFETY STRAP (60M)
å
for added stability.
NOTE: Do not turn the SAFETY DRYWALL ANCHOR (61M) into a wall stud. If you prefer to fasten the SAFETY
å
STRAP (60M) to a wall stud, go to your local hardware store for proper hardware.
INSTALLATION INSTRUCTIONS: (Also available at www.yl-anchors.com)
å
1. Insert the SAFETY DRYWALL ANCHOR (61M) through the WASHER (13M) and one end of the SAFETY STRAP (60M).
2. Using a Phillips screwdriver or a hand drill, press screw slightly onto the drywall.
3. Apply pressure; turn the screw until a pilot hole is made and the nylon sheath slips through.
4. Turn the screw until it is fl ush against the wall and you feel a fi rm resistance.
5. Continue to turn until the screw starts spinning freely.
Insert the other end of the SAFETY STRAP (60M) through the gap between the BACKS (E), then use a BLACK 9/16"
å
LARGE HEAD SCREW (1S) through the SAFETY STRAP and into the pre-drilled hole in the underside of the TOP (C).
NOTE: Before moving your unit to a diff erent location, unscrew the SAFETY DRYWALL ANCHOR (61M) from your wall.
å
The nylon sheath will remain behind your wall.
www.sauder.com/services
E
C
E
BLACK 9/16" LARGE HEAD SCREW
(1 used in this step)
417886
13M
61M
60M
1S
Page 17
Publicidad
