Publicidad
Step 4
NOTE: The unit can be positioned horizontally or vertically.
å
Carefully stand your unit upright against the wall in its fi nal location. If you are standing your unit horizontally, the
å
SAFETY STRAP is not needed.
NOTE: The following instructions show your vertical unit being fastened to a wall stud. If you are not fastening your unit
å
to a wall stud, go to the next step now.
1
st
- Locate the center of a stud in your wall near your unit and mark it with a pencil just below the top surface of your
å
unit so the SAFETY STRAP will not be visible.
nd
2
- Drill a 1/8" hole on the mark and into the stud in your wall.
å
rd
3
- Fasten the unit to the wall. Use the LONG SCREW through the other end of the SAFETY STRAP and into the 1/8" hole.
å
Mark and drill
a 1/8" hole into
the wall stud.
st
1
96
430616 / 211-4715
Electric drill with 1/8" bit
nd
2
3
rd
www.sauder.com/service
A
Page 7
Publicidad
