Uline H-2489A Instrucciones De Montaje página 3

Figure 1
17
Figure 2
PAGE 3 OF 15
18
ASSEMBLY
JOINING UNITS TOGETHER
1. Bolt the horizontal frame to the two vertical frames
as shown in Figure 1 (use 5 bolts and nuts per side).
Do not use the center bottom hole on either side;
these will be used for attaching the coat rod.
(See Figure 1)
2. With the help of a second person stand unit upright.
3. Slide coat rod brackets (6) over the coat rod (7).
From left to right, bolt coat rod brackets to the
bottom of the horizontal frame. The bolts on either
end will be placed through the bottom center holes
of the vertical and horizontal frames to attach the
brackets. (See Figure 2)
4. Move to desired location. Check and secure
all bolts.
SECURING UNITS
1. Anchor units to wall or floor. Unanchored units may
fall over if not secured. (Units standing back to back
should be bolted together.)
CAUTION: Care must be taken to assure
that lockers are set plumb and true before
anchoring.
2. If units are not pre-numbered, optional number
plate and plastic covers (3) may be attached with
two push plugs (4). (See Door Detail on page 2.)
1220 IH-2489A