Renfert SIMPLEX Manual De Instrucciones página 38

Printing is complete:
♦ For easier removal of the object, the print bed is automatically lowered a little
and the print head is moved to the home position�
en
♦ A corresponding message is shown on the display. This can be confirmed
with "OK".
Caution! Danger of burns!
The print head and print bed could still be hot.
Wear protective gloves!
⇒ If necessary, you can use the "AXES" menu (see Chap. 5.5) to lower the print bed further.
⇒ Remove the object from the print bed. Carefully remove the object with one hand using a slight twisting
motion while holding the print bed with the other hand. If the object is difficult to remove, use the spatula
provided�
Take care not to scratch the Kapton film.
So that removal of the object is as easy as possible, wait until the print bed has cooled.
If necessary, you can also remove the build plate from the printer to remove the object�
To do this, loosen the fixing clasps on the front right and left of the print bed and remove the build plate.
When reinserting, ensure that the build plate has been inserted in the correct end position and that the
fixing clasps are closed.
An incorrectly seated build plate can cause misprints or damage to the printer.
- 18 -
Fig. 38
Subject to change