Publicidad
Idiomas disponibles
Idiomas disponibles
Refrigerator Door
1. Remove the door handles. See the model specific graphics
later in these instructions.
Door Handles installed with flat-head screws and setscrews:
Remove the screws from the top of the refrigerator door
handle.
Remove the setscrew from the lower part of the handle.
Pull the handle away from the door to release it from the
shoulder screw. Keep all parts together.
Door handles installed with flat-head screws only:
Remove the screw cover, and the three flat-head handle
screws. Keep all parts together.
2. Remove door hinge hole plug from refrigerator door. Move
to opposite side hinge hole as shown. See Graphic 3.
3. Remove door handle sealing screws. Move to opposite side
of refrigerator door as shown. See Graphic 4.
4. Remove door handle hole plug and discard it. See Graphic
7. Replace on opposite side with the door handle hole plug
provided in the Reversibility Kit located in the crisper.
5. Remove door stop. Move to opposite side of refrigerator
door as shown, making sure that the hole in the door stop
plate is aligned perfectly with the hole for the Bottom Hinge
pin. See Graphic 5.
6. Position refrigerator handle on opposite side of the
refrigerator door as shown. See Graphic 6. First, drive top
two screws in handle, and then align lower portion of handle
and drive bottom screw into handle. Depending on your
model, place the handle on the shoulder screw and push the
handle toward the door until the mounting base is flush
against the door.
7. Tighten all screws. Set aside refrigerator door until bottom
hinge is installed on refrigerator.
8. Depending on your model, replace screw cover. See
Graphic 6.
Replace Doors and Hinges
NOTE: Graphic may be reversed if door swing is reversed.
1. Replace the parts for the bottom hinge as shown. Tighten
screws. Replace the refrigerator door.
NOTE: Provide additional support for the doors while the
hinges are being moved. Do not depend on the door
magnets to hold the doors in place while you are working.
2. Measure the distance from the bottom of the refrigerator
door to the floor. The distance should be approximately 3¹⁄₂"
(88 mm).
NOTE: If necessary, loosen the bottom hinge, without
removing the screws, adjust the door to the correct height
and fully tighten the screws.
10
All manuals and user guides at all-guides.com
3. Assemble the parts for the center hinge as shown and
4. Assemble the parts for the top hinge as shown. See Top
5. Line up the doors so that the bottom of the freezer door
1. Check all holes to make sure that hole plugs and screws are
2. Remove the cover from the base grille. Move the cover to
3. Align the clips on the base grille with the screws on the
4. Plug into a grounded 3 prong outlet.
5. Reset the controls. See "Using the Control(s)."
6. Return all removable door parts to doors and food to
tighten all screws. See Center Hinge graphic. Replace the
freezer door.
Hinge graphic. Do not tighten screws completely.
aligns evenly with the top of the refrigerator door. Tighten
all screws.
NOTE: The distance between the doors should be
approximately ⁵⁄₈" (16 mm).
Final Steps
in place. Reinstall top hinge cover. See Top Hinge graphic.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
the opposite side.
bottom of the cabinet. Push the base grille toward the
cabinet until it is flush.
refrigerator.
Publicidad
