Publicidad
Idiomas disponibles
Idiomas disponibles
First try the solutions suggested here or visit our website to possibly avoid the cost of a service call.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
If you experience Possible Causes and/or Recommended Solutions
The refrigerator
Not connected to an electrical supply - Plug the power cord into a grounded 3 prong outlet. Do not use
will not operate
an extension cord.
No power to the electrical outlet - Plug in a lamp to see if the outlet is working.
Household fuse blown or circuit breaker tripped - Replace the fuse or reset the circuit breaker. If the
problem continues, contact an electrician.
Control is not turned on - Turn the refrigerator control on.
New installation - Allow 24 hours following installation for the refrigerator to cool completely.
NOTE: Adjusting the temperature control(s) to coldest setting will not cool the refrigerator more quickly.
The motor seems to
Your new refrigerator may run longer than your old one. Energy efficient refrigerators run longer at lower,
run too much
more energy efficient speeds. Your refrigerator may run even longer if the room is warm, a large food load is
added, the door is opened often, or if the door has been left open.
The refrigerator is
Refrigerator noise has been reduced over the years. Due to this reduction in operating noise, you may notice
noisy
unfamiliar noises that are normal. Following are some normal sounds with an explanation:
Buzzing - heard when the water valve opens to fill the ice maker
Clicking/Snapping - valves opening or closing
Pulsating - fans/compressor adjusting to optimize performance
Rattling - flow of refrigerant, water line, or from items placed on top of the refrigerator
Sizzling/Gurgling - water dripping on the heater during defrost cycle
Popping - contraction/expansion of inside walls, especially during initial cool-down
Water running - may be heard when ice melts during the defrost cycle and water runs into the drain pan
Creaking/Cracking - occurs as ice is being ejected from the ice maker mold
The door will not
The door is blocked open - Move food packages away from door. Push bin or shelf back into the correct
close completely
position. Make sure the crisper cover is fully pushed in, so that the back rests on the supports.
The door is difficult
Gaskets are dirty or sticky - Clean gaskets and contact surfaces with mild soap and warm water. Rinse
to open
and dry with soft cloth.
All manuals and user guides at all-guides.com
PROBLEM SOLVER
WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
19
Publicidad
