Publicidad
Idiomas disponibles
Idiomas disponibles
Reverse Doors (optional)
IMPORTANT: If you want to reverse your doors so that they
open in the opposite direction, follow these steps. If you are not
reversing the doors, see "Replace Doors and Hinges."
Graphics follow these instructions.
Door Hinge
Cabinet Hinge
Hole Plug
Hole Plug
Dome Cap
Dome Cap
Washer
Shoulder
Screw Washer
Cabinet
1. Remove the three dome caps and the screws from handle
side and move them to opposite side. See Graphic 1-1.
2. Using the three ⁵⁄₁₆" hex-head hinge screws, removed in
Step 1, insert two screws halfway into the holes, leaving
space to insert the center hinge.
3. Once the refrigerator door is in place, slide the center hinge
from the right onto the screws, insert the third screw, and
then tighten all screws completely.
NOTE: Make sure the washers are in place on both the top
and bottom pins of the center hinge.
A
A. ⁵⁄₁₆" Hex-head hinge screws
B. Washers
4. Remove cabinet hinge hole plugs from cabinet top and
move them to opposite side hinge holes as shown.
See Graphic 1-2.
All manuals and user guides at all-guides.com
Setscrew
Door Stop
Screw
Shoulder
Flat-Head
Screw
Handle
Screw
Door Handle
Hole Plug
B
Freezer Door
1. Remove the door handles. See the model specific graphics
later in these instructions.
Door Handles installed with flat-head screws and setscrews:
Remove the two flat-head handle screws from the
bottom of the freezer door handle.
Using the ¹⁄₈" hex key, loosen the setscrew attaching the
top of the handle.
Pull the handle away from the door to release it from the
shoulder screw. Keep all parts together.
Door handles installed with flat-head screws only:
Remove the screw cover and the three flat-head handle
screws. Keep all parts together.
2. Remove door hinge hole plug from freezer door. Move to
opposite side hinge hole as shown. See Graphic 3.
3. Remove the brand badge using the plastic tool (provided).
Replace it with the badge provided in the Reversibility Kit
located inside the crisper drawer. For proper placement, see
the Brand Badge Placement template (the last page of this
manual).
NOTES:
To avoid scratching the finish, do not use a sharp or
metallic object to pry the brand badge from the door.
Rub a small amount of liquid dish soap over any
adhesive residue with your fingers. Rinse the door with
warm water and dry with a soft cloth.
4. Remove door handle hole plug and discard it. See
Graphic 7. Place the new door handle hole plug (provided in
the Reversibility Kit located in the crisper drawer) into the
hole on the opposite side of the door.
5. Depending on your model, remove the shoulder screw and
its washer from the left-hand side of the door and fasten it
into the hole on the opposite side.
6. Remove door stop. Move to opposite side of refrigerator
door as shown. See Graphic 5.
7. Position freezer handle on opposite side of the freezer door
as shown. See Graphic 2. First, drive the bottom two screws
into handle. Align upper portion of handle and drive top
screw into handle. Depending on your model, place the
A
handle on the shoulder screw and push the handle toward
the door until the mounting base is flush against the door.
8. Tighten all screws. Set aside door until hinges and
refrigerator compartment door are in place.
9. Depending on your model, replace screw cover. See
Graphic 2.
9
Publicidad
