Inglesina Caboto 1.2.3 IFIX Manual De Instrucciones página 18

USE OF THE VEHICLE SAFETY BELT
(ONLY IN CONFIGURATION 15-36 KG)
9. With the child placed in the child car seat pass the diagonal
section of the vehicle's seat belt through the upper guide (7). Fasten
the vehicle seat belt buckle and make sure the belt is not too loose
by gently pulling the diagonal part of the belt before placing it over
the child's chest.
Check that the lap section of the vehicle's belt is passing through
the lower belt guide (14).
USE OF THE HEADREST AND SAFETY BELT ADJUSTMENT
10. To adapt the harness (8) and the headrest (1) to the correct
position press the lever (6) and pull the headrest upwards acting
simultaneously on the tensor (10). The harness will automatically
move upwards without doing anything more. Place the harness in
the correct position showed in the diagram.
15-36 KG
Use the same lever (6) to adapt the height of the headrest to the
growth of the child.
Make sure that once the child is positioned and the headrest is
properly adjusted, the seat belts are always about 2 cm above the
child's shoulders.
If you need to lower the position of the harness or of the headrest
do the same operation in reverse.
18
9-18 KG
HOW TO RECLINE THE CHILD CAR SEAT
11. The child car seat can be reclined to make it more comfortable
for the child.
To recline the child car seat press the lever (12) and pull forward
until it reaches the desired position.
CHILD CAR SEAT MAINTENANCE
FITTING/REMOVING THE COVER
To remove the fabric cover, unfasten the 7 fastening points on the
front part and gently detach the lateral plastic parts.
To put the cover back on again just follow the same process in
reverse making sure to insert correctly the parts into the slots on
the sides.
CLEANING
The cover can be hand washed using a mild detergent and at
a maximum temperature of 30°. Please refer to the washing
instructions on the care label of the cover.
Do not tumble dry.
Do not expose the fabric cover to the sunlight for prolonged
periods; when the child car seat is not in use cover it up or store it
in the vehicle boot.
The plastic parts can be cleaned with a damp cloth and a neutral
detergent.