Publicidad
DEVICE OVERVIEW
See technical figures on cover pages.
1.
Impact resistant polycarbonate
base layer
2. Scratch & scuff resistant lens
3. Incident exposure indicator LED's
4. Device Power On / Off indicator
5. Audio recording indicator
6. Low Battery indicator
7.
Power / Record button
8.
Strap harness attachment point
9.
Device serial number and barcode
RF MONITOR OPERATION
Prior to entering an area where
‚
transmitting antennas could be
present be sure to switch your
fieldSENSE60 on.
Switch the fieldSENSE60 on by
‚
pressing and holding the Power
button for approximately 1 second.
The LEDs illuminate in sequence
‚
ALWAYS ADHERE TO THE RELEVANT SAFETY REGULATIONS
PERTAINING TO RF EXPOSURE IN THE COUNTRY OF USE.
10. Heavy duty shock absorbing
elastomer outer layer
11. Lanyard attachment point
12. USB connection for data logging
(NOT FOR CHARGING)
13. Date Calibration Expires
14. Tripod attachment point
15. AAA Alkaline batteries (LR03)
16. Battery lid removal screws (M2)
followed by a BEEP. Once on, the
power indicator will flash.
Should the battery level be low, the
‚
low battery indicator will illuminate.
Replace the batteries with AAA
alkaline batteries.
Should the exposure level rise above
‚
50% an audible alarm is sounded.
1
Publicidad
