Publicidad
When close to or exceeding 100%
‚
of the exposure limit, the necessary
precautions need to be taken.
Once switched on the field strength
‚
data logger will record all field
values measured every second.
These are accessible via the PC
application available from
www.fieldsense.com.
EXPOSURE LOGGING
Once the fieldSENSE60 is switched
on the cumulative exposure from all
sources present within the operating
frequency and exposure dynamic range
are stored as the Maximum, E and H
percentages with the associated date
and time thereof.
It is important to synchronize your
‚
device time to your local time by
plugging it into a PC running the
FieldSENSE app available from
www.fieldsense.com.
The reported and recorded values
‚
are a percentage of the associated
exposure guideline power density,
either referenced to the E or H field.
2
Once the fieldSENSE60 is on, the fall
‚
detection & alarm system is armed
and in the event of a fall being
detected an alarm will sound which
can only be cleared by switching the
device off and on again.
To ensure that the device is not
‚
inadvertently left switched on
causing unnecessary drain on the
batteries a timer will switch the unit
off after 8 hours.
Data points are stored at up to once
‚
every second in a changing field. In
static field conditions or below the
device noise floor less points are
stored to conserve memory.
A 6-minute average is also
‚
calculated and stored.
Accessing these values and
‚
synchronizing the date/time of
the device is achieved using the
FieldSENSE app available from
www.fieldsense.com.
Publicidad
