Publicidad
VOICE NOTES
The fieldSENSE60 can also capture
voice notes which are paired with the
measured data.
Once the device is on, double tap
‚
the power button and the Audio
recording LED will illuminate.
Speak directly into the front of the
‚
device slowly and clearly for best
performance.
FALL DETECTION & ALARM
The fieldSENSE60 is equipped with a
tri-axis accelerometer which is able to
detect if the device experiences a fall.
This is immediately activated
‚
when the device is on, and should the
device detect a fall of approx. 2m
it will sound the alarm.
REPLACING THE BATTERIES
When the Low Battery Indicator begins
to flash, replace the batteries.
It is NOT possible to charge the
‚
device through the USB port, this is
exclusively for access to data and
voice logs.
REMOVING THE BATTERIES FOR AN EXTENDED PERIOD OF TIME WILL
CAUSE THE DEVICE TO LOSE TIME ON THE INTERNAL CLOCK. THIS IS
CORRECTED BY PLUGGING IT INTO THE USB CONNECTION ON A PC
‚
‚
‚
‚
‚
‚
‚
RUNNING THE FIELDSENSE APP.
A single short press of the power
button will end the audio recording
session, but the RF monitor remains on.
Voice notes can be downloaded
from the fieldSENSE60 using the app
available from www.fieldsense.com.
The alarm can only be cleared by
switching the device off.
This is to draw attention to a climber
who may be in need of support.
The alarm, if uncleared, will continue
until the batteries are exhausted.
Open the elastomer flap at the
bottom of the fieldSENSE60
revealing the battery lid screws (16).
Remove the screws (16) and lid (14)
and slide out the old batteries (15).
Dispose of these correctly.
3
Publicidad
