Descargar Imprimir esta página

Loewe L 2 A Manual Del Usuario página 30

Altavoces activos

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
Active loudspeaker - L 2 A
Passive mode
Connect your hi-fi amplifier and the speaker with
a speaker cable. To fix the cable use the terminal
screws on the baseplate of the speaker.
Connect the marked wires of the speaker cable
with the plus terminals (+) of the speaker and the
amplifier. The other wire should be connected to
the minus terminals (-). In this way you will
ensure that the speakers are connected in the
same phase.
+
AUDIO
CHANNEL
L
R
POWER
INPUT: 230V≈ 50/60 Hz
30
Active mode as front
speakers
Connect the LINE IN input on the speaker with
the AUDIO OUT output on the decoder. For this
purpose use the cinch cable which is supplied.
Initially leave the INPUT SENSITIVITY controller in
the middle position.
Use the mains cable to supply the built-in ampli-
fier with voltage.
-
PASSIVE
RF
INPUT
LINE
CHANNEL
SENSITIVITY
IN
MIN
MAX
1
2
Fuse
T1AL
250V
Active mode as
rear speaker
The L2A is suitable for use as a rear speaker in a
Surround Sound system
For this pupose connect the cinch cable to the
decoder output, which is marked with SUR-
ROUND or REAR.
Radio connection
A radio connection will be obtainable early in the
year 2000 as a retrofitting set, in order to save the
cinch cable in the particular use as a rear speaker.
To have the retrofitting work done by specialists
please contact your specialist dealer.
Passive input
INPUT SENSITIVITY
Level controller
LINE IN
Active input
Mains socket
Fine fuse
T1AL 250V
Caution: Before opening the housing pull out
the mains plug!

Publicidad

loading

Este manual también es adecuado para:

59201