[PCS] settings
You can set or check the PCS settings and status.
NOTE
y All the values on the [PCS] screen should not be edited by user It may cause system
malfunction if you change the values by user.
y Viewable information names are listed below -
Stable Volt Mode, fixed cosPhi Type, fixed cosPhi Setpoint, cosPhi(P) Type, cosPhi(P) Start,
cosPhi(P) End, cosPhi(P) PowerStart, cosPhi(P) PowerEnd, fixedQ Reactive Setpoint, Q(U) Xa,
Q(U) Xb, Q(U) Xc, Q(U) Xd, Q(U) Ya, Q(U) Yb, Q(U) Yc, Q(U) Yd, EV Meter Enable ,PV Setting
y When changing the option values of [PCS] menu, refer to 'Others' on page 85 for more
information.
Select [PCS] on [Installer Settings]. PCS
information is displayed.
[Pcs]
All the setting options and values of PCS
information are displayed
[Battery Only Mode], [Feed in limitation],
[Installation Date] options can be changed
manually.
Set the options as described below.
1. Select the currently selected value. Input
menu appears on the screen.
2. Input desired value.
3. Select [Save] to complete the setting.
Tap [Grid] , [System] or [System2] to show more
setting options for the PCS.
Settings
47
.
3