Publicidad
Installation
Consider that this location of the transceiver should not interfere with the
driver and passengers. Choose a spot where the microphone and all
controls are easily accessible.
(1) Put the mounting bracket on the proper location where you are going
to install.
Drill holes and fix mounting bracket on the location.
(2) Connect the antenna cable plug to the standard receptacle on the
transceiver, which is marked "ANT".
(5) Mount the microphone bracket on one side of the transceiver, or
near it using two screws included.
TCB-900
(3) Connect the power cable
directly to the vehicle battery or
fuse box of the car. Be careful to
make sure of the polarity of the
battery first and connect the
cable.(Red: Positive Pole(+),
Black: Negative Pole(-). The
same colours are shown on the
battery and in the fuse box of
the car.)
(4) Connect the power cable to
the transceiver cable.
Connect the microphone to the
transceiver's microphone recep-
tacle. Now you are ready to
operate the transceiver.
English 5
Publicidad
