Publicidad
Idiomas disponibles
Idiomas disponibles
The position indicated by "I" excludes the timer, which continues to work, but the convector remains always on. In the "0"
position, the timer continues to work but the convector is always off
SETTING
Make sure the timer switch is in the center position.
Rotate the outer ring of the timer clockwise until the current time is aligned with the arrow,
example: if it is 8:00 in the evening, rotate the ring until 20 in line with the arrow.
Set the time when the convector is turned on by removing the segment (or segments) on the outer ring corresponding to the
time in which the convector is to be switched on. Each segment has a duration of 15 minutes. After setting, the convector will
operate every day as programmed, as long as it is plugged into a power outlet and if the heating element switch and
thermostat are turned on.
If continuous operation is required, set the timer selector to position "I". If you want to return to timed operation, move the
selector back to the central position
NOTE: using the timer function, pay attention to the fact that the convector will turn on even if unattended.
CLEANING AND MAINTENANCE
Before cleaning, always disconnect the product from the mains and allow it to cool.
Clean the outside of the convector with a soft cloth. Do not allow water to enter inside.
Do not use detergents or abrasives.
CONFORMITY OF THE PRODUCT
The producer Melchioni Ready S.r.l. declares that the product Convector heater Mod. THERMAL (cod. [158640023) is in
compliance with Directive 2014/30/EU of the European Parliament and of the Council, of 26 february 2014, on the
harmonisation of the laws of the Member States relating to electromagnetic compatibility.
The producer Melchioni Ready S.r.l. declares that the product Convector heater Mod. THERMAL (cod. [158640023) is in
compliance with Directive 2014/35/EU of the European Parliament and of the Council, of 26 february 2014, on the
harmonisation of the laws of the Member States relating to the making available on the market of electrical equipment
designed for use within certain voltage limits.
The producer Melchioni Ready S.r.l. declares that the product Convector heater Mod. THERMAL (cod. [158640023) is in
compliance with Directive 2009/125/EC of the European Parliament and of the Council, of 21 october 2009, establishing a
framework for the setting of ecodesign requirements for energy-related products.
The producer Melchioni Ready S.r.l. declares that the product Convector heater Mod. THERMAL (cod. [158640023) is in
compliance with Directive 2011/65/EU of the European Parliament and of the Council, of 8 june 2011 and subsequent
Commission Delegated Directive 2015/863, on the restriction of the use of certain hazardous substances in electrical and
electronic equipment.
According to Directive 2012/19/EU of the European Parliament and of the Council, of 4 july 2012, on waste electrical and
electronic equipment (WEEE), the presence of the crossed-out bin symbol
indicates that this appliance is not to be
considered as urban waste: its disposal must therefore be carried out by separate collection. Disposal in a non-separate manner
may constitute a potential harm to the environment and health. This product can be returned to the distributor when
purchasing a new device. Improper disposal of the appliance constitutes misconduct and is subject to sanctions by the Public
Security Authority. For further information, contact the local administration responsible for environmental matters.
Publicidad
