Service & Maintenance - Altrad Belle GROUP RANGER 450 Manual Del Operador

GB
The Belle Group Floor Saw is designed to give many years of trouble free operation. It is, however, important that the simple regular
maintenance listed in this section is carried out. It is recommended that an approved Belle Group dealer carries out all major
maintenance and repairs. Always use genuine Belle Group replacement parts, the use of spurious parts may void your warranty.
Before any maintenance is carried out on the machine ensure that the machine has been stopped.
• Always set the Floor Saw on level ground to ensure any À uid levels will be correctly read.
• Only use recommended oils.
Running In Period
When the Floor Saw is ¿ rst used from new, the engine oil must be changed after the initial running in period (see engine manual
for full detail). The belt tension should be checked after 4 hours use.
Drive Belt.
Remove the belt guard then check the belt tension by placing light ¿ nger pressure on the top of the belt, as near central between the
engine drive and arbor pulley. The belt should deÀ ect by between 5mm and 10mm. If the belt tension requires adjustment, adjust the
engine's position by turning the tension bolts clockwise to increase belt tension, anticlockwise to decrease. Once set, retighten the
engine mount bolts and check the belt tension a second time. Then check the pulley alignment. If the alignment is incorrect, loosen the
taperlock bushes and move the pulley to suit. Once the pulley is aligned, retighten the taperlock bushes. Finally, replace the belt guard
ensuring it is correctly and securely ¿ tted.
Routine Maintenance
Engine Oil Check Level
Change
Air Filter Check Condition
Clean / Replace
Spark Plug Check / Clean
Drive Belt Tension
Oil / Fuel Type & Quantity - Spark Plug Type
Petrol Honda GX390
Petrol Robin EH41
Diesel Lombardini LD 440
Service and Maintenance
After ¿ rst
4 hours
9
9
Oil type Quantity
(Litre)
S.A.E. 10W 30 1.1
S.A.E. 10W 30 1.2
Refer to Manual 1.5
First month
/ 20h
9
9
9
Fuel Type Capacity
(Litre)
Unleaded 6.5
Unleaded 7.0
Diesel Refer to
BS2869 Manual
12
3 months 6 months
/ 50h / 100h
9
9
9
9
9
Spark Plug Electrode
Type Gap (mm)
BM6ES or 0.6 - 0.7
BPR6ES
BM6ES or 0.7 - 0.8
N9Y
N/A N/A