AudioSonic CL-1563 Manual De Instrucciones página 7

. Press the ON/OFF button to turn off the device.
Tips for better reception
FM: For best reception fully unwind the FM wire antenna at the rear of the unit.
AM: The unit comes with a built-in ferrite antenna. For best reception change the direction of the unit.
CD
1. Press the ON/OFF button to turn on the device. The indication POWER turns on.
. Slide the function selector to the CD position.
. Open the door of the CD drive by pressing the OPEN button. Place a CD with the label facing
upwards on the CD compartment and close it again. The total number of tracks will be shown for
 seconds. Afterwards the current time will be displayed again.
. Start the playback by pressing the PLAY/PAUSE button.
Track indication
Press during playback of a CD the DISPLAY button to show the current track number (for a few sec-
onds). In the stop mode the total number of track is shown.
Playback/Pause
1. If the PLAY/PAUSE button is pressed in the stop mode, the playback of the first track starts.
. If the PLAY/PAUSE button is pressed in the playback mode, the playback is paused and the track
number flashes for 2 seconds on the display.
Stop playback
If the STOP button is pressed in the playback or pause mode, the playback is stopped and the total
number of tracks will be shown on the display.
Selection of a different track
1. Press I<< / MINUTE or >>I / HOUR, until the desired track number is shown on the display.
. Press shortly I<< / MINUTE to return to the beginning of the current track.
3. Press I<< / MINUTE again (within 1 second after the first key stroke) to skip back one track at a
time.
. Press >>I / HOUR to skip to the next track.
Search for a certain position (only during playback)
Press and hold I<< / MINUTE or >>I / HOUR to search for the desired position within the track. Nor-
mal playback continues if the button is released. In search mode the volume is reduced.
Repeat mode
Press the REPEAT/RANDOM button during playback and the current played track or the whole CD
can be repeated. Each press switches the repeat mode:
1. Repeat current
track
The REPEAT indicator
flashes
Programming
Up to 20 tracks at an Audio and CD can be programmed in a specific sequence.
1. Press the ON/OFF button to turn on the device. The indication POWER turns on.
. Slide the function selector to the CD position.
2. Repeat all tracks 3. Random play-
The REPEAT indica- The RANDOM indi-
tor is steadily on. cator is steadily on.
GB-6
4. Turn off repeat mode/ran-
back dom playback
The indicators for REPEAT and
RANDOM are turned off.