AQV OK770 Manual De Instrucciones página 21

card slot of the dash cam. (You need to format the TF card
in the dash cam when you use it for the first time)
2.Remove the protective stickers from the dash cam and the
Suction Mount.
3.Attach the suction cup bracket to the top of the camera
and tighten the threads.
4. Securely attach the Suction Mount to the windshield, plug
the car charger into the car cigarette lighter, and the other
end into the USB port of the dash cam. (The charging
extension cable can be laid along the edge of the car
windshield when wiring.)
5. Adjust the device position:Loosen the knob on the right
hand side of the mounting bracket, and adjust the vertical
and horizontal angle of the camera. To make sure you get
the best coverage over the hood and the road ahead, so
you can record what happens. Tighten the knob to lock the
position of the camera.
6. Start the car. The camera will auto power on and start
recording.
4.3 Powering the Dash Cam On /Off
Auto Power On/Off
Install and connect the dash cam to your vehicle's power
supply properly. The dash cam switches on / off
automatically when the engine ignition of the vehicle is
switched on / off.
Set Auto Power Off in the menu: Off, 1 minute, 3 minutes, 5
minutes.
Manual turn on / off
Long press power button.
16