Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Problem
Engine will not start.
Leaving Swirls in Concrete.
Rolling Concrete.
Bouncing.
If some of the above mentioned problems occur, please check the following:
GB
Your new Belle Group Pro Trowel is warranted to the original purchaser for a period of one-year (12 months) from the original date of
purchase.
The Belle Group warranty is against defects in design, materials and workmanship.
The following are not covered under the Belle Group warranty:
1. Damage caused by abuse, misuse, dropping or other similar damage caused by or as a result of failure to follow assembly,
operation or user maintenance instructions.
2. Alterations, additions or repairs carried out by persons other than Belle Group or their recognized agents.
3. Transportation or shipment costs to and from Belle Group or their recognized agents, for repair or assessment against a warranty
claim, on any machine
4. Materials and/or labor costs to renew, repair or replace components due to fair wear and tear.
The following components are not covered by warranty.
· Drive belt
· Engine air ¿ lter
· Engine spark plug
Belle Group and/or their recognized agents, directors, employees or insurers will not be held liable for consequential or other
damages, losses or expenses in connection with or by reason of or the inability to use the machine for any purpose.
Warranty Claims
All warranty claims should ¿ rstly be directed to Belle Group, either by telephone, by Fax, or in writing.
Tel: +44 (0)1298 84606 Fax: +44 (0)1298 84722
Email : Warranty@belle-group.co.uk
Write to:
Belle Group Warranty Department,
Sheen, Nr. Buxton
Derbyshire,
SK17 0EU,
England
Troubleshooting Guide
Cause
No fuel.
Engine switched off.
Spark plug fouled.
Engine cold.
Engine À ooded.
Cutout Switch in OFF position.
Main Shaft
Spider Plate
Blades
Remedy
Open fuel tap.
Fill fuel tank
Switch engine on.
Clean and reset plug gap.
Close choke.
Open choke, fully open throttle, pull recoil starter until engine
¿ res.
Move Cutout Switch to ON position.
When the machine has a rolling motion, check the main
shaft of the gearbox.
Check Spider plate for bent trowel arms. If one is bent
replace it.
Check the adjustment on trowel arms at adjustment lever, and
ensure all trowel arms are adjusted equally.
Blades should be of the same measurement / dimension and
designed to ¿ t the machine.
Excessively worn blades should not be used.
Warranty
16
.
Publicidad
Tabla de contenido
