Vortice SOFT DRY Folleto De Instrucciones página 11

!
Precaution:
• Don't make any changes of any kind on the unit.
• Don't leave the unit exposed to the weather.
• Don't rest any objects on the unit.
• The unit must only be installed by a qualified
technician.
• Perform a thorough visual inspection on the unit at
regular intervals. If you find any imperfections, don't
operate the unit and immediately contact your
Vortice Service Center.
• The electrical system to which the unit is to be
connected must comply with the existing norms.
• Since your unit is doubly insulated, the mains outlet
to which it is connected need not be grounded.
• Don't connect the unit to an electrical outlet that
doesn't have the right power rating. If the outlet
doesn't have the right power rating immediately
contact a qualified electrician.
• When installing the unit, provide a omnipolar switch
that has a contact gap of at least 3 mm.
• When installing the unit in a public place, you should
also install a thermal or differential switch in series
in the circuit.
• Use the unit in the vertical position, as indicated by
the manufacturer. The air outlet must point
downwards.
• If a load greater than 10W is connected to the
electrical outlet, the unit's automatic device cuts off
the power delivery. The unit is again ready for use
The power-source data must be consistent with the
electrical data shown on the nameplate A.
this symbol indicates that care must be taken to avoid damaging your product
after the automatic device has reset itself.
• In case of overheating, the unit's special safety
device deactivates the resistance and then
reactivates it when the temperature normalizes.
• Before reusing the unit, wait for its temperature to
normalize (about one minute). The interruption of the
flow of warm air is not an abnormality but actually
represents greater safety for the user.
• Don't obstruct the air-outlet nozzle.
• Don't attach any accessories to the air-outlet nozzle
that did not come with the unit.
• Don't insert any foreign objects into the hose
through the air-outlet nozzle.
• When using the unit, just hold it by its handle, and
don't squeeze the hose, because this will impede
the air flow.
• Don't put lighted cigarettes on the unit.
• Don't put out cigarettes on the unit's housing.
• When finished with the unit, always rehook the air-
outlet nozzle.
• If you should drop the unit or if it receives a sharp
blow of any kind, have it immediately checked at
your authorized Vortice Service Center.
• If your unit malfunctions or fails to operate, turn off
the switch, disconnect the unit from the electrical
outlet and contact your Vortice Service Center for
having the unit repaired. Be sure to ask them to use
only genuine Vortice spare parts if required.
!
Don't pull on the hose.
11