Ryobi PCG006 Manual Del Operador página 5

„ Latches should snap into place to ensure charger is
correctly connected.
„ Do not place the charger in an area of extreme heat or
cold. It will work best at normal room temperature.
„ The battery pack may become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
„ When the battery pack is more than 80% charged and
ready for use, the green LED will begin fading on/off
continuously.
„ After the battery is fully charged, the green LED will remain
on while the charger is in Energy Save Mode.
„ Charger will periodically wake from Energy Save mode to
ensure the battery pack remains in a fully charged state.
„ To remove the battery pack from the charger, depress
latches and pull up on the battery pack.
„ When the battery pack is fully charged, remove it from
the charger.
LED FUNCTION OF CHARGER
RED
MODE
Standby
Temperature
Flashing
Delay
Error
Flashing Flashing Error
• Try to repeat the conditions a second time by removing and reinstalling the battery pack. If the LED Error status repeats
a second time, try charging a different battery.
• If a different battery charges normally, dispose of the pack that received the Error (see your battery pack manual for
instructions).
• If a different battery also indicates Error, the charger should be replaced.
Charging
Ready
Charged/
Energy Save
Mode
NOTE: Maintenance information begins on page 6 after French
and Spanish language sections. Illustrations start on page 7.
OPERATION
GREEN
BATTERY PACK
LED LED
Multiple battery
ON OFF
packs installed
Hot Battery Pack
OFF
Cold Battery Pack
OFF Flashing Charging
More than
OFF Fading
80% charged
Battery full /
OFF ON Energy Save
mode
CHARGING A HOT BATTERY PACK
When using a tool continuously, the battery pack may be-
come hot. A hot battery pack may be placed directly onto
a battery port but charging will not begin until the battery
temperature cools to within acceptable temperature range.
When a hot battery pack is placed on the charger, the battery
port's LED will begin flashing red. When the battery pack
cools, the charger will automatically begin charging.
NOTE: Each battery port has its own LEDs.
CHARGING A COLD BATTERY PACK
A cold battery pack may be placed directly onto the charger
port but charging will not begin until the battery temperature
warms to within acceptable temperature range. When a cold
battery pack is placed on the charger, the battery port's LED
will begin flashing red. When the battery pack warms, the
charger will automatically begin charging.
NOTE: Each battery port has its own LEDs.
Waiting to charge battery pack; product will attempt to
charge battery packs in the order that they are installed.
When battery pack reaches cooled temperature,
charger begins charge mode.
When battery pack reaches warmed temperature,
charger begins charge mode.
Battery pack or charger error.
Battery is being charged.
Fast-charging phase complete. Battery pack may be
used. Battery will finish charging at a reduced rate until
fully charged.
Battery pack is fully charged and charger is in
Energy Save mode.
5 — English
ACTION