Step 5
å
Turn two CAM SCREWS (6) into the UPRIGHT (D).
å
Carefully turn the UPRIGHT (D) over.
å
Push four HIDDEN CAMS (5) into the UPRIGHT (D).
å
Turn three CAM SCREWS (6) into the exact holes shown in the UPRIGHT (D).
å
Fasten one EXTENSION RAIL (1) to the UPRIGHT (D). Use two 1/2" FLAT HEAD
SCREWS (19) through the exact holes shown.
å
NOTE: Turn a SCREW into the 1
inner cartridge of the EXTENSION RAIL in to find the other hole that lines up with the
hole in the UPRIGHT. Turn a SCREW into this hole.
1/2" FLAT HEAD SCREW
(2 used in this step)
1
st
Page 10
hole shown in the enlarged diagram. Then, slide the
st
19
1
Arrow
5
www.sauder.com/service
6
1
D
Open end
1
1
st
This hole
must be here.
D
6
427328